All You Need to Know About the Best Decorative Concrete
If you want a beautiful addition to your property, you can add stamped concrete. However, if it is poorly done, it will turn out badly for you and the contractor as well. During the process of stamping, it is vital that there are no spots left unattended to because these issues will only be noticed after the process is all done. This is why you need a contractor that has experience because they have probably been in these scenarios and they know how to prevent them. There are several tricks that will help achieve better texture and they are listed below. It is important to make sure that you stamp as early as possible. You do not need a tamper as you will need to just walk on the stamps into the surface if you start stamping early.
The next useful tip you could use is setting the retarders and slow evaporation. It is possible to assume that the slab has already become hard enough just because you can see that it has crusted. The crust will start cracking as soon as you start stamping and you find yourself sinking. The reason why you apply the evaporation retarder is so that the surface dries well. Retarders usually slow down the evaporation process so that you the slab is properly textured.
The slab needs to be crawled as the next step. Get kneeboards and send the people out before you go ahead with the stamping. The surface is going to be worked up because of the weight as well as the vigorous floating of the slab. This will make sure that the slab has the same consistency and stamping becomes easier. You will easily get the results you want this way. If the slab starts to get ahead of you, you can always save the situation by rolling the surface. Getting texture is easier this way.
You can wear textured shoes as great tools for you to stamp the slab. Do not expect any straps or buckles on stamping shoes and they use friction to be held in place. Once you wear these shoes, you will have the weight spreading over a wide area and you do not have to fear that you will sink. It is always advisable that you start in the middle of the slab going out. This technique ensures that there are no different textures on the slab and the stamping will be more uniform this way at both ends. The only thing you will need to note about this technique is that you will need to have more stamps than normal so that you get the consistency you are looking for.